Roller derby is played on all kinds of floors. We skate on a wooden floor that has qualities that shift with the weather. What this means is that we tend to skate on different wheels in the different seasons. Harder wheels (ranges 90+) allow for more speed and slide and less grip, softer wheels have more grip but may feel slower at times (78-88). I’m currently skating on 92 (summer, so the floor has grip of its own), but in winter I skate on a mix of 84 and 88. If we play on a soft sport court floor elsewhere, we go up in wheel hardness, last weekend, I skated on 98. What this means is that I have accumulated an almost uncomfortably large amount of wheels.
I used to store all my wheels in ziplock bags and tried to stack those, but they always rolled everywhere. So a little while ago, I went on the hunt for patterns for wheel bags. In the end I resorted to an adapted version of a zippered box pouch. There wasn’t a ‘right size’ pattern online that I could quickly find, so I resorted to making a scale version from paper to determine how it worked exactly.
After the scaled version was completed, I drew it out in the right measurements, added seam allowance and got on with it. The considerations where the the bottom should be flat for the bag to stand on, there should be enough zipper to allow the two stacks of wheels to enter and exit the bag, it should not be so large that the wheels slide around and it needed a carry strap. I cut out the first iteration and sewed it together. My wheels are also different sizes, I have one set of 38 x 59 mm (S), one set of 38 x 65 mm (L) and 3.5 sets of 38 x 62 mm (M).
The first bag (black mushrooms) was too large for the medium wheels, it needed about a cm in width reduction, but the large wheels fit in fine. For the second iteration (yellow mushrooms) I removed a cm along the width sides but I made a mistake in making the bottom smaller, so that one has an additional pleat. It again didn’t fit the M wheels, but the S wheels fit in fine. Next attempt, I reduced the width by .5 cm and made the correct adjustment on the bottom. This version fit the M wheels, so I cut out another and found that I didn’t have the right length zipper anymore. So I shortened the height by 8 cm on my paper pattern (which was a little too much in hindsight) for the half set and cut it out. I did have a zipper long enough for that one, so it was sewn together quickly. At night, I went to the sewing supplied shop and got more zippers – luckily it was the one night a week where the sewing shop was open until 21:00.
All of these bags are made from waterproof tablecloth fabric. The first and second fabric have also been used for the EDC, the pineapple fabric was already in the hoard for pouches, but I never got around to it. All pouches have a carry strap from a bit of fabric left over from some part of pouch making. I specifically gave the pineapple pouches different coloured zippers and carry straps to be able to differentiate the wheels inside with a single look. I will also add labels to the outside. For some non-deliberate reason, all my harder wheels (88+) are black. All the softer wheels (84-) are green. Happy coincidence? Anyway, my wheel pouches are now nicely stacked two high in the closet with less chance of them falling over and rolling everywhere. So far, this project feels successful.
